Welcome! Becoming a registered user of ShortWingPipers.Org is free and easy! Click the "Register" link found in the upper right hand corner of this screen. It's easy and you can then join the fun posting and learning about Short Wing Pipers!

Page 7 of 7 FirstFirst ... 567
Results 61 to 64 of 64

Thread: Wing STC

  1. #61
    Stephen's Avatar
    Join Date
    Nov 2007
    Location
    Lopez Island, WA
    Posts
    2,970
    Post Thanks / Like

    Default Re: Wing STC

    Quote Originally Posted by Just Call Me Al View Post
    Which stamped metal rib works best with a squared off wing tip extension? Would a butt rib? Or is there a full length rib?
    Thank you in advance.
    I used a full length regular rib for the outter rib although, a butt rib should work fine. Make sure you use plenty of angle supports to keep the rib from warping when you tighten the fabric. I would use them on both sides of each spar on upper and lower wing surfaces. You can even double them up by installing a short one then a longer one.
    "You can only tie the record for flying low."

  2. #62
    Just Call Me Al's Avatar
    Join Date
    Aug 2015
    Posts
    16
    Post Thanks / Like

    Default Re: Wing STC

    Sorry for my ignorance, but that is why I lurk on this forum. Which rib is better? Wouldn't the LH butt rib on the RH wing tip wok best since it is made for the end of the spar? Just trying to figure out the correct application since the product pictures on the Internet catalogs have verying degrees of accuracy. Thanks for the "tip" on bracing or doubling to prevent fabric pulling.

  3. #63
    Administrator Steve Pierce's Avatar
    Join Date
    Nov 2007
    Location
    Graham, Texas, United States
    Posts
    11,103
    Post Thanks / Like
    Blog Entries
    1

    Default Re: Wing STC

    It would be plenty stiff because it has the flange for the tank bay cover spot welded to it.

  4. #64
    Stephen's Avatar
    Join Date
    Nov 2007
    Location
    Lopez Island, WA
    Posts
    2,970
    Post Thanks / Like

    Default Re: Wing STC

    Quote Originally Posted by Just Call Me Al View Post
    Sorry for my ignorance, but that is why I lurk on this forum. Which rib is better? Wouldn't the LH butt rib on the RH wing tip wok best since it is made for the end of the spar? Just trying to figure out the correct application since the product pictures on the Internet catalogs have verying degrees of accuracy. Thanks for the "tip" on bracing or doubling to prevent fabric pulling.
    Yes, it will work fine. I have installed the outter stamped ribs curved in and curved out. It really does not matter. Curved out gives you an extra 1/2 inch of wing span. I'm remembering that my outter ribs do not have the slots for the spar. I used 1" aluminum angle, cut to fit the spar web. I double the angle piece so it fits each side of the web. I bolt everything with AN 3. Obviously, line the outter rib with the other ribs. Another reason to install the outter rib curved out is after the fabric work is done you can slide on tinnerman or clip nuts to attach the wing tip. If you are using ribs with spar slots I would still face them curved out and bolt them on with angle pieces, I wouldn't trust screwing them like the other ribs.
    Last edited by Stephen; 10-05-2018 at 04:16 PM.
    "You can only tie the record for flying low."

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •