Welcome! Becoming a registered user of ShortWingPipers.Org is free and easy! Click the "Register" link found in the upper right hand corner of this screen. It's easy and you can then join the fun posting and learning about Short Wing Pipers!
Thanks:
0
Likes:
0
-
No elevator inspection plates/covers on Colt
Howdy, have a colt with no inspection covers/plates at the elevator bell crank in the tail, need to remove elevator, don't want to create a disaster, any tips on cutting the fabric and installing the inspection plates? Thanks!
-
Administrator
Re: No elevator inspection plates/covers on Colt
How in the word did they install them? Can you post a picture? Only way I can think would be to slit a grommet and glue it on. After it has dried cut it out and then glue another one on the inside.
-
Re: No elevator inspection plates/covers on Colt
I'll send an image ASAP, it has AeroThane on the fabric. Not familiar with the PA-22 series yet to know what it is supposed to have on it, looked at Univairs online parts catalog and found the grommets and covers, how is this supposed to attach originally? Thanks!
-
Administrator
-
Re: No elevator inspection plates/covers on Colt
Thanks, that is a big help!
-
Re: No elevator inspection plates/covers on Colt
colt tail 002.jpgcolt tail 001.jpgOk, here's how the problem was dealt with, cut 2 little holes out to remove the lower bolt. Will put the grommets on and life will be good. The little colt is loved at her new home!
-
Administrator
Re: No elevator inspection plates/covers on Colt
Looks like you you could put a simple patch over those till you have to pull the elevators.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules