I made the landing gear fittings today. I will make the tooling for welding them onto the fuselage next.Landing Gear Fitting 1.jpgLanding Gear Fitting 3.jpgLanding Gear Fitting 2.jpg
I made the landing gear fittings today. I will make the tooling for welding them onto the fuselage next.Landing Gear Fitting 1.jpgLanding Gear Fitting 3.jpgLanding Gear Fitting 2.jpg
Door sheet metal going back on after replacing vertical tubingCargo Door Post 1 Rebuild.jpgStarboard Door Post 1 Rebuild.jpg
It's always great when you finally get to paint some parts after clean upPainted parts 1.jpgPainted parts 2.jpg
Looks like it is going in the right direction.
It looks like you are having fun.
"You can only tie the record for flying low."
More landing gear fittings and installation tooling. I have been missing for a bit. I have been busy with school and the big annual vintage motocross event that I help put on once a year.
Landing Gear Fitting 4.jpgLanding Gear Fitting 5.jpgLanding Gear Fitting 6.jpgLanding Gear Fitting 7.jpgLanding Gear Fitting 8.jpgLanding Gear Fitting 9.jpgLanding Gear Fitting 10.jpgLanding Gear Fitting 11.jpgLanding Gear Fitting 12.jpg
I like that gear fitting jig. No doubt about alignment of the gear.
Great landing gear jig. How much difference in the spans between the front and rear gear attachments did you allow?
"You can only tie the record for flying low."