Welcome! Becoming a registered user of ShortWingPipers.Org is free and easy! Click the "Register" link found in the upper right hand corner of this screen. It's easy and you can then join the fun posting and learning about Short Wing Pipers!
Thanks:
0
Likes:
0
-
Naugahyde cable seals
I'm recovering the tail feathers of an Aeronca Champ. Where the trim table cables penetrate the elevator I intend to use the Piper Naugahyde cable seals. Polyfiber was unable to give my advice on when and how to apply them. I found this surprising since they're fairly widely used.
Do I put them on bare fabric or after the Polybrush and Polyspray? Cement them with PolyTac or Polybrush?
Thanks much
Paul
Salome, AZ
-
Re: Naugahyde cable seals
on my champ I just used a patch made of fabric. I think that's all that is called out on the print. on my wagabond I used naugahyde with 3m weatherstrip adhesive but over time the edges lifted a little bit.
-
Administrator
Re: Naugahyde cable seals
I put them on with 3M weatherstrip adhesive after painted. Piper glued them on and painted over them.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules