Wanted: Clipper control sticks.

[SClow303]

I am looking for a set of sticks for clipper to use in my experimental build.... or could also be hooked up with a someone that could bend up a set for me!

[Stephen]

I made a set for my Pacer. I did not need to make as deep of a bend since I set my linkages more forward than the Clipper. I made a jig out of wood and heat bent the tubing.

Make sure that your bend is deep enough so than when your seat is forward you get full aft stick control.

[AKJurnee]

My Clipper sticks are out, I can trace them on a piece of cardboard if you need an outline.

[Steve Pierce]

I have found that rolling an exact copy of a Clipper stick is very difficult. There is a lot of radius. The guy that rebuilds the Stromberg carburetors in the Chicago area had a race car fabrication shop build qome, they are not cheap but exact copies and have the push to talk built in.

[SClow303]

Yeah, when Charlie built these he had a little trouble getting the radius in there without some kinks. I was just thinking if I could find a set that I would switch them out.