View Full Version : Floats for a Clipper
SuperClipper
05-28-2009, 02:21 PM
I am in the process of rebuilding a clipper and would like to add provisions for floats. Where is a good place to start to obtain information on doing this (parts needed, STC's etc)?
Thanks, Ted.
Steve Pierce
05-28-2009, 03:58 PM
The Type Certificate Data sheet lists the Edo 1650. There is an installation drawing on the SWPC Drawing CD. Don't have anymore details than that other than a few contacts with 150 hp Clippers on floats.
Stephen
05-28-2009, 04:12 PM
You might contact Hailstorm, he may have some floats for sale from his Pacer.
Powered by vBulletin® Version 4.2.4 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.