Welcome! Becoming a registered user of ShortWingPipers.Org is free and easy! Click the "Register" link found in the upper right hand corner of this screen. It's easy and you can then join the fun posting and learning about Short Wing Pipers!

Likes Likes:  0
Results 1 to 4 of 4

Thread: Tail flying wires hardware

  1. #1

    Join Date
    Jun 2012
    Posts
    54
    Post Thanks / Like

    Default Tail flying wires hardware

    I have misplaced my parts CD. I noticed during a preflight that one the radius plates under the thru bolt that hold the thru bolt to the vertical tail post was missing. I had a extra set with hardware, so I changed them out and put two new radius plates as the AD requires and a new thru bolt and nut. I need to check to insure the hard ware is correct.

  2. #2

    Join Date
    Jun 2012
    Posts
    54
    Post Thanks / Like

    Default Re: Tail flying wires hardware

    I installed an AN bolt and a AN365 nut, does that sound correct?

  3. #3
    Administrator Steve Pierce's Avatar
    Join Date
    Nov 2007
    Location
    Graham, Texas, United States
    Posts
    11,762
    Post Thanks / Like
    Blog Entries
    1

    Default Re: Tail flying wires hardware

    Yes, 1/4" bolt and no washers just the curved ones.

    • AN4-15A BOLT: QTY 1
    • U40131-00 BENT WASHER: QTY 2
    • AN365-428 NUT: QTY 1
    • AN3-15A BOLT: QTY 2
    • AN365-1032 NUT: QTY 4
    • U82732-72 BUSHING: QTY 4
    • AN3-5A BOLT: QTY 2
    Last edited by Steve Pierce; 05-21-2019 at 06:29 AM.

  4. #4

    Join Date
    Jun 2012
    Posts
    54
    Post Thanks / Like

    Default Re: Tail flying wires hardware

    great, that is what I have. Thank you for the help

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •