Welcome! Becoming a registered user of ShortWingPipers.Org is free and easy! Click the "Register" link found in the upper right hand corner of this screen. It's easy and you can then join the fun posting and learning about Short Wing Pipers!
Thanks:
0
Likes:
0
-
To shrink or not?
After reading a recent thread that recommended a modified set of jaws for a metal shrinker, I began to think where I could use one.
Where the lower bowl attaches to the lower nose bowl, there is excess material between some of the screw holes. Would use of a shrinker between these points solve this and correct the radius or would it just bring the screw holes closer together?
Although reportedly easy to accomplish, I am reticent to build a whole new cowl.
regards
Dean
IMG_3204.jpg
Last edited by dhillier; 06-08-2020 at 07:28 AM.
Reason: photo
-
Administrator
Re: To shrink or not?
Only time I have had to shrink the lower cowl was when installing a fiberglass nose bowls that had the wrong angle on the attach lip. I would roll an edge on what you have pictured using a tool like this.https://www.aircraftspruce.com/catal...ryedgetool.php
-
Re: To shrink or not?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules