throttle and mixture clamps

[Curly]

Oh no your not! I didn't take anywhere near enough - and my memory is going to hell in a handbasket. :?
(My Mum told me I would go blind if I didn't stop it - she didn't say anything about it affecting your memory!)

[Steve Pierce]

Been there and done that. I have more than I can count on the kid's Tri-Pacer and still found a bracket under the floor that I had no idea what was attached to it and no pictures. Luckily I was looking for something else in the parts manual and stumbled on it. It holds the rear seat SCAT hose as it goes under the pilots floor board.

[N2709P]

Steve, do you still have those pictures of how the throttle/mixture clamp on the motor mount is orientated? They seem to have disappeared off the site.
Thanks!
N2709P

[Steve Pierce]

I believe these are the pictures from the original post and then some because I found where i had down sized them as I use to have to do before the software upgrade. These are the best I have of the throttle and misture controls.

100_0048.JPG

100_0061.JPG

100_0064.JPG

100_0069.JPG

[N2709P]

Thank you Steve!

[walt.buskey]

And I went down to "the hangar" today to put in a new tach cable, so I took some pics -- hope these may also help (and hope mine isn't upside down!).

-- Notice those two nice, new cables??? (Ouch....$$$ )

DSC00621.JPGDSC00623.JPG

[N2709P]

Thanks to you also Walt! I should be able to install it properly between your and Steve’s pictures. ��
N2709P