Early Pacer trim pulley

[1950 PacerFlyer]

Looking for help trying to find part number for trim crank pulley ( pulley above crank handle ) on a 1950 PA-20 single groove. Univair said they can only tell me if they have it, if I give them a part number. I have the short wing drawing CD. I see the double groove setup drawing, but cannot find the single groove set up. Found both drawings for rear yoke setup. Single and double. Also looked through PA-16 drawing list and not seeing anything on crank assembly. If someone would know the correct part number for pulley or drawing number for the single groove assembly where I could find the part number it would be much appreciated.
Thanks Rob

 

[Smokey]

https://www.univair.com/piper/piper-j-5/view-all/u10080-000-piper-trimcrank-pulley-2-75-x-3-8-inch/

Ouch!

 

[dgapilot]

I’m switching to the double groove pulley system in my Clipper. I’m pretty sure it is the same part number for the Clipper and Pacer. You are welcome to my old pulley if you want it, just pay shipping. It has 1200 hours on it.


Sent from my iPad using Tapatalk